Disassembly and Reassembly
178 Samsung Electronics
No Parts Procedure Remark
4 Control-Box
1) Disconnect the Connector Wire that is con-
nected to the indoor unit’s PBA from the PBA.
2) Unscrew the 2 fixed screws on both sides of
the Control Box, and disassemble the Control
Box from the indoor unit. (Use +Screw Driver)
5 Bell-Mouth 1) Unscrew the screw fixed on the Bell-Mouth.
(Use +Screw Driver)
2) Push the Bell-Mouth in the direction
opposite to where it’s installed on the
Control-Box to remove it.
To Next Page
Loading...
