Disassembly and Reassembly
310 Samsung Electronics
No Parts
Procedure Remark
2 CONTROL-IN
(Continues)
3) Rotate CASE PCB 90 degrees as shown in
figures.
(Watch out for damage of hinge in CASE PCB)
4) Separate Fan Moter wire as shown in figures.
Caution:
When you separate the connector, pull pressing
the locking button.
5) Separate Blade Moter wire as shown in figures.
Caution:
When you separate the connector, pull pressing
the locking button.
6) Cut off the Cable Tie tied up wires.
To Next Page
Loading...
