Samsung AN17HS - Page 4

3 Disassembly and Reassembly
This section of
qe
service
manual
describes
the
disassembly
and
reassembly
pro
ANIZHS/ANI71IS/ANI9MS/AN19IS/
ANIOMT
monitor,
:
WARNING:
This
monitor
contains
electrostatically
sensitive
devic
handling
these
components.
3-1 Disassembly
$e trata stmecn
t the monitor from the power sourc
e before disa
embly
2.
To
remove
the
Rear
Cover,
you
must
use
the
special
opening
jig
3.
R/Cover
opening
jig
:
BH81-00001A
a}.
elease the snaps on the rear stan
R
the stand bac ds from the moni
th
grooves at each s
le opening jig into the
and press until it cilcks.
2.
When
the
snaps
on
the
rear
cover
releasel,
lift
up the rear cover and set a 3
de. Remove 3
rews from the rear top shield.
screw to-remoy from the CRI
socketboard.
“eaee emt
eneee
9.
10.
nnecter from.
RT DY
Remove the CRT ground wire
CRT soket. Next, remove the C
connecter from the main bo
Remove the degaussing wire connecter and
cter form the main board
tilbwire conr
Diconnect the function board connecter. Then
separate the connecter from the main board
shield by passing it through the hole of ma
board shield.
Remove the 4 screws at CRT corners. Lift up
the CRT from the monitor front.
Remove CRT from the front cover.