Disassembly and Reassembly Procedure(AW0801B)
No. Part Name Procedures Remarks
4 Frame up
1..Remove 2 screws on the frame up and case
cond.
2.Remove all the screws on the frame up.
3.Pull the frame up upward.
5 Blower
1.Remove 3 screws on the evaporator.
2.Pull the evaporator from frame low carefully.
3.Remove the nut and remove the Blower.
6 Case Cond &
Fan Propeller
& Motor Fan
1.Remove 2 screws on the rear side of the
base pan, and all screws fixed on case cond.
2.Pull up the condenser from the base pan.
3.Remove the nut and remove the Propeller
fan.
4.Remove the earth screw(fix the motor earth
wire), then take out the motor upward.
4-6 Samsung Electronics
To Next Page
Loading...
