Samsung CLP-31 Series - Page 72

Alignment & Troubleshooting
Service Manual
4-15
Samsung Electronics
4.1.6.3(e) Maintenance
Item Discription
Fuser When “select” key is pushed, “Initialized” message will be displayed.
When “Upper Level” is pushed, “Off” message is disappeared.
Transfer When “select” key is pushed, “Initialized” message will be displayed.
When “Upper Level” is pushed, “Off” message is disappeared.
FCF Pick Up Roll When “select” key is pushed, “Initialized” message will be displayed.
When “Upper Level” is pushed, “Off” message is disappeared.
SCF Pick Up Roll When “select” key is pushed, “Initialized” message will be displayed.
When “Upper Level” is pushed, “Off” message is disappeared.
ITB When “select” key is pushed, “Initialized” message will be displayed.
When “Upper Level” is pushed, “Off” message is disappeared.
4.1.6.3(e) Maintenance
▶
Paper Empty / Paper Mismatch
- Load specied paper in the tray 1
• Paper does not exist in the tray1
• Load Paper, When you still want to continue printing
- Paper mismatch in the tray 1
• Paper is mismatched
• Press stop key for a while, When you still want to continue printing
▶
Cover Open
- Cover Open
• Cover is opened
• Close the door, When you still want to continue printing
▶
Waster Tank Full or not installed
- Waste Tank Full
• Toner of Waste toner box is full
• Empty or Insert the waste toner box
▶
Paper Jam
- Paper Jam at the tray1
• Paper is not picked up
• Cover Open /Close, When you still want to continue printing
- Paper Jam inside printer
• There is a paper inside printer
• After cover Open , Paper must be removed, and then close the cover