Samsung CLP-600 Series - Paper Feeding Problems and Troubleshooting; Top Margin Error; Jam 0

Samsung Electronics
Service Manual
Troubleshooting
7-10
Symptoms :
Printing begins at wrong position on the paper.
Check and Cause Solution
Wrong sensor timing caused by defective feed sensor
actuator.
Replace the defective actuator
7.3.2 JAM 0
Symptoms
1. Paper has not exited from the cassette.
2. "Jam-0" occurs even though the paper feeds into the printer.
7.3.1 Top Margin Error.
7.3 Paper Feeding Problems and Troubleshooting
MPF Path
Check and Cause Solution
1. Check the Feed Solenoid or Pick-
Up using EDS Mode.
2. Check that the Separator Pad has
not become loose.
3. Check if the surface of the Pick-Up
Roller is clean.
4. Check the Feed Sensor is not
sticking by using the EDC Mode
(When “JAM-0” occurs even
though the paper feeds into the
printer.)
1. Replace the Solenoid.
2. Replace the Separator - Pad
(inside the Cassette).
3. Clean the surface of the Pick-Up
Roller with IPA or water.
4. Replace the main PBA or Sensor.