In the fuser unit area
If paper is jammed in the fuser unit area, follow the
next steps to release the jammed paper.
1. Open the scan unit rst and then inner cover.
2. Holding the inner cover open, carefully take the
jammed paper out of the machine. The inner
cover will then close automatically. Lower down
the scan unit gently until it is completely closed.
Make sure that it is securely latched. Printing
automatically resumes.
3. To remove the jammed paper, open the rear
door.
4. Carefully remove the paper by pulling in the
direction as shown below. Most of the jammed
paper can be removed in this step.
5. Close the rear door. Printing automatically
resumes.
To Next Page
Loading...
