4.1.9 Error Message
Messages appear on the control panel display to indicate the machine’s status or errors. Refer to the tables
below to understand the messages’ meaning and correct the problem if necessary. Messages and their
meanings are listed in alphabetical order.
Code LCD message Symptom Solution
S2-4110 Door open
Close it
Ther front door is not securely
latched.
1. Close the door until it locks into
place.
2. Check if the cover open switch
is work properly. If it is defective,
replace it.
3. If the problem persists, replace
the main PBA.
A1-1113 Error #A1-1113 Your machine’s memory has
become full while trying to store an
original into memory.
To cancel the fax job, press the OK
button to accept Yes.
If you want to send those pages
that have been successfully stored,
press the OK button to accept No.
You should send the remaining
pages later, when memory is
available.
Call for
service
The motor does not
work properly.
Check if the motor is working.
If the motor is not working,
reconnect the motor connector or
replace the motor.
Ask the sender to try again.
A3-3311 Error #A3-3311 Connection with the SMTP server
failed.
Check the server settings and the
network cable.
Call for
service
Temperature sensor
has some problem.
1. Turn the power button off and on.
2. Check the output of the temp.
sensor.
3. Replace the main board.
Try again.
C1-2110 Prepare Toner
∇
Small amount of toner is left in the
yellow cartridge.
The estimated cartridge life of toner
is close.
Prepare a new cartridge for a
replacement.
To Next Page
Loading...
