4.1.7 EDC Mode
EDC Mode is independently controled system F/W and Diagnose printer’s each function.
■ Method to enter
After Power On, wait a minute(about 30 seconds)
And, it is displayed to panel, “Ready to XXXX”
Execute EDC Program, click to Menu key.
And, it is displayed to application “EDC Main <Motor Test>”
Next, to use below key, test edc mode.
■ Keys
Key Description
Exit Close program
Update LCD Update value (ex : sensor value)
Menu Move to the top menu
Left/Right arrow Move test item
Enter Start testing or select Sub-item
Upper level Stop testing or the upper menu
■ Menu Organization
To Next Page
Loading...
