4-75
Troubleshooting
● Possible Cause:
1. Pickup Clutch does not work.
2. Pickup roller rubber is worn out.
3. Feed Sensor is defective.
● Error message : Paper jam in MP tray
● Troubleshooting method :
● Symptom :
At printing, the paper from the MP tray has not reached to the feed sensor within a programmed period of
time after pick up.
● Code : 01-004
1. Enter the EDC mode, and execute the pick up clutch test
(EDC mode : 101-0000)
If there is any problem, check the following.
-. Check if the MP Pick-Up Clutch is assembled properly.
-. Check if the harness of the MP Pick-Up Clutch is connected
properly.
2. Check if the Harness is defective.
Check if the connector is connected properly.
To be continued on next page…
To Next Page
Loading...
