4-76
Troubleshooting
● Troubleshooting method :
4. Check the following.
-. Check if the Feed Sensor is assembled properly.
-. Check if the harness of the Feed Sensor is
connected properly.
-. Enter the EDC mode. Execute the Feed Sensor test.
(EDC Mode Î Test Routines Î Copier Engine/DADF
Test Routine Î 102-290 Î Start Î Status check Î
Stop)
5. Check if the Harness is defective.
Check if the connector is connected properly.
3. Check if the MP pick up roller is worn out.
To Next Page
Loading...
