4-215
Troubleshooting
Step 3. Checking default status
Scale
Slit Hole Center Hole
A screw fasten to the center hole.
The original position of the bracket is fixed at the center hole (In the production line, a screw is fasten at
the center hole). If excessive skew does show on the image, it is possible to improve the skew quality by
repositioning the bracket.
NOTE
The default position of the bracket ensures the image skew well within the designed spec. If the copied
output is satisfactory, it is recommended to keep the default position and do not adjust the skew further.
To Next Page
Loading...
