4-217
Troubleshooting
Expected
Image
Media
C
o
p
i
e
d
i
m
a
g
e
From the output, skew needs to be adjusted and image is as shown below,
Using the scale on the bracket, change
the bracket position gradually, and
check the results.
1. Remove the screw from the center hole
2. Push the bracket in the arrow direction to change the
bracket position . Pushing the idle roller connected to the
bracket may be easier to adjust the location of the bracket.
3. Fix the bracket at the new position by screw fastening
at the slit hole.
Screw in the
right side of
the slit hole
To Next Page
Loading...
