Samsung CLX-9250ND - Page 182

3. Replaceme
n
Reassembling the cartridge transfer
1. Install the ITB frame on the Frame Install JIG(A). In
s
top and bottom.
NOTE – Belt Serial No. must be toward the bottom.
Belt Guide JIG(B)
Frame Install JIG
(
A
)
()
NOTE
1. Before assembling the belt, clean the frame roller (
D
spray and alcohol.
2. When reassembling the belt, be careful not to be st
a
2 Assembling is reverse order of the disassembling
2
.
Assembling
is
reverse
order
of
the
disassembling
.
Note
A
fter assembling the belt, check the inside Rib position
Both Ribs must be located below of the Drive roller, Te
OK Example
NG Example
Service Manual
CLX-9250/9350 series
3-
5
n
t Procedures
unit
s
tall the Belt Guide JIG(B). And assemble the belt from
(Inside of the Belt)
Belt Serial No.
(Inside
of
the
Belt)
D
rv, Tension,Guide A,Guide B,Bk Nip) by using the air
a
bbed or contaminated.
of the belt.
nsion roller.
SAMSUNG ELECTRONICS
5
4