Samsung CLX-9250ND - Video Controller

3. Replaceme
n
3.7.3 Video controller PBA
1. Remove the Rear cover and Rear shield.
Perform the following procedure to remove the Video
C
2. Take off the Top Slot [A] after removing 5 screws.
[A]
CAUTION
Observe precautions
For handling
Electrostatic
Sensitive
Devices
3. Take off the Bottom Slot [B] after removing 2
screws.
[B]
Service Manual
CLX-9250/9350 series
3-
5
n
t Procedures
4. Take off the video controller after removing 8
scre s and all connectors
C
ontroller PBA from the printer.
scre
w
s
and
all
connectors
.
MSOK
CAUTION
When replacing the Video board, you must
insert the MSOK and Memory on the new video
PBA.
SAMSUNG ELECTRONICS
5
8