Samsung CLX-9250ND - Page 288

4.Servi
c
• Diagnostics > Adjustment > Finisher Ad
j
ust
m
Purpose To correct alignment of print ou
t
function would be very rare and
standardized.
Operation
1
Choose one item from the
Operation
Procedure
1
.
Choose
one
item
from
the
• Front Tamper Position (
ⓐ)
• Rear Tamper Position (ⓑ)
2. Select one item and press t
h
3. Change the adjustment val
u
to rear position, while - val
u
4. Press the “OK” button to ap
Verification
Print out and check the stack of
Verification
Print
out
and
check
the
stack
of
Specification
Front Tamper Position Unit: m
m
Rear Tamper Position Unit: mm
Reference
Rear
ⓐ
ⓑ
Finishing Tray
Front
Service Manual
CLX-9250/9350 series
4-
3
c
e Mode
m
ent > Tamper Position
t
stack at finishing tray. Note that use of this
would be required if the size of paper is not
table There are two items to choose
table
.
There
are
two
items
to
choose
.
h
e edit button.
u
e with arrow button. + value moves the position
u
e moves the position to front position.
ply the new value to the system.
paper is aligned correctly
paper
is
aligned
correctly
.
m
, Scale: 0.1, Min/Max: ±50mm
, Scale: 0.1, Min/Max: ±50mm
Finisher
Front Cover
SAMSUNG ELECTRONICS
3
9