Samsung CLX-9250ND - Page 419

7. Trouble
s
● Code :
M1-1213
● Error message :
Paper jam in tray 2.
● Symptom / Cause :
Paper transport jam (paper Input section)
- The paper has not reached the tray2 feed sensor wi
t
● Troubleshooting method :
1. Open the side & take away door. Remove the jam
m
Close the Side door. After warm u
p,
if same
j
am oc
p, j
2. Install the Pick up (forward, retard )roller correctly.
3. If the pick up roller is worn out or contaminated, re
p
4. Check if papers in the cassette are curled, replace
t
5. Check if the wall connector of tray2 pick up unit is
c
6. If the problem persists, remove the pick up unit and
A
. If the spring at the bottom of the pick up unit brea
k
If the assembly mold part with spring is broken, r
e
B. If the com
p
ression s
p
rin
g
of the
g
uide-forward
p
ic
ppgg
p
C. If the error message displays despite paper empt
y
interrupt. Reassemble the empty actuator or repla
In case that the actuator is broken, check the followin
g
1. Does the pick up (forward) roller rotate?
ACh kifth lth t fth ik di
A
.
Ch
ec
k
if
th
e c
l
u
t
c
h
connec
t
or o
f
th
e p
i
c
k
up
d
r
i
ve
u
B. Enter the diagnostic mode. Execute “clutch test” .
C. If the timing belt of the pick up drive unit breaks a
w
D. Check if the motor connector of the pick up drive
u
E. Enter the diagnostic mode. Execute “motor test” .
2. Re
p
lace the en
g
ine controller.
pg
● Replacement part
- JC93-00174A : FRAME MAIN-PICK UP SECOND
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7-
7
s
hooting
t
hin normal time after pick up.
m
ed paper.
curs
,
check the followin
g
.
,g
p
lace it.
t
he paper or stretch to remove curling.
c
onnected properly. Reconnect the connector.
check the following.
k
s away or is broken, replace the spring.
e
place it.
k u
p
breaks awa
y,
reassemble or re
p
lace it.
py, p
y
in the cassette, check the empty actuator and photo
ce the photo interrupter.
g
:
it i t d l R t it
u
n
it
i
s connec
t
e
d
proper
l
y.
R
econnec
t
it
.
If it is defective, replace it.
w
ay or is broken, replace it.
u
nit is connected properly. Reconnect it.
If it is defective, replace it.
SAMSUNG ELECTRONICS
7
9