Samsung CLX-9250ND - Page 420

7. Trouble
s
● Code :
M1-1610
● Error message :
Paper jam in MP tra
y
● Symptom / Cause :
Paper transport jam (paper Input section)
- The paper has not reached the regi sensor within no
r
● Troubleshooting method :
1. Remove the jammed paper from the MP tray.
2. Open the side door. Remove the jammed paper.
Close the Side door. After warm up, if same jam oc
c
3. Install the Pick up (forward, retard )roller correctly.
4. If the pick up roller is worn out or contaminated, rep
5 Check if papers in the MP tray are curled replace th
5
.
Check
if
papers
in
the
MP
tray
are
curled
,
replace
th
6. Open the side door and remove the lower cover fro
m
the MP tray unit and the connector of the joint PBA ar
e
7. If the problem persists, remove the MP unit from th
e
A
. If the spring at the bottom of the MP unit breaks a
w
If the assembly mold part with spring is broken, r
e
B. If the spring of the guide to fix the pick up roller in
M
C. If the error message displays despite paper empt
y
interrupt. Reassemble the empty actuator or repla
c
D. If the driving gear breaks away or is broken, reas
s
In case that the actuator is broken, check the following
In
case
that
the
actuator
is
broken,
check
the
following
1. Does the pick up (forward) roller rotate?
A
. Check if the MP clutch connector is connected pr
o
B. Enter the diagnostic mode. Execute “MP clutch te
s
C. Check if the motor connector of the MP drive unit
i
D. If MP solenoid on but pick up roller moves down,
c
reassemble it
reassemble
it
.
E. Enter the diagnostic mode. Execute “MP drive mo
t
2. Replace the engine controller.
● Replacement part
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
-
JC92
-
02239A : PBA
-
ENGINE (CLX
-
9250ND)
Service Manual
CLX-9250/9350 series
7-
8
-
JC92
-
02239A
:
PBA
-
ENGINE
(CLX
-
9250ND)
s
hooting
y
.
r
mal time after MP pick up.
c
urs, check the following.
lace it.
he paper or stretch to remove curling
he
paper
or
stretch
to
remove
curling
.
m
the rear of the side unit. Check if the connector of
e
connected properly. Reconnect the connector.
e
side unit and check the following.
w
ay or is broken, replace the spring.
e
place it.
M
P unit breaks away, reassemble or replace it.
y
in the cassette, check the empty actuator and photo
c
e the photo interrupter.
s
emble or replace it.
g:
g
:
o
perly. Reconnect it.
s
t” . If it is defective, replace it.
i
s connected properly. Reconnect it.
c
heck for each link, part missing, part defect. And
t
or test” . If it is defective, replace it.
SAMSUNG ELECTRONICS
8
0