Samsung CLX-9250ND - Page 422

7. Trouble
s
● Code :
M2-1211
M2-1213
M2-1214
M2-1221
● Error message :
Paper jam inside of
m
● Symptom / Cause :
Paper transport jam (paper Input section)
1. The paper has not reached the regi sensor within n
o
2. When opening the side door, the paper is detected
a
● Troubleshooting method :
1. Open the side (take away) door. Remove the jamm
e
Close the side (take away) door. After warm up, if s
a
2. If there is any obstacles between the tray1 feed roll
e
3. Check if the idle roller on bottom of the side unit is f
i
reassemble the idle roller. .
In case of the electrical part problem, check the follow
i
1. Check if the reflective connector, junction connecto
1.
Check
if
the
reflective
connector,
junction
connecto
Reconnect the connector.
2. Enter the diagnostic mode, and check the reflective
If the paper is at sensor and “Without paper” messa
g
3. Enter the diagnostic mode, and check the motor tes
If the motor is broken replace it
If
the
motor
is
broken
,
replace
it
.
4. Check if the regi connector of engine controller is c
o
5. Replace the engine controller.
● Replacement part
- JC31-00132A : MOTOR STEP
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7-
8
s
hooting
m
achine.
o
rmal time after passing the tray1 feed sensor.
a
t the regi sensor.
e
d paper.
a
me jam occurs, check the following.
e
r and the regi roller, remove it.
i
xed correctly. If or not, disassemble the Guide and
i
ng :
or on the middle of
regi
roller are connected properly.
or
on
the
middle
of
regi
roller
are
connected
properly.
sensor test.
g
e is displayed, replace the sensor.
t of the pick up drive unit.
o
nnected properly. Reconnect it.
SAMSUNG ELECTRONICS
8
2