Samsung CLX-9250ND - Page 423

7. Trouble
s
● Code :
M2-1321
M2-1324
M2-1325
● Error message :
Paper jam inside of
m
● S
y
mptom / Cause :
y
1. The paper has not reached to the Fuser In sensor
w
sensor.
2. When opening the side door, the paper is detected
a
● Troubleshooting method :
1. Open the side (take away) door. Remove the jamm
e
Close the side (take away) door. After warm up, if s
a
2. If there is any obstacles between the tray1 feed roll
e
3. Check if the idle roller on bottom of the side unit is fi
3.
Check
if
the
idle
roller
on
bottom
of
the
side
unit
is
fi
reassemble the idle roller.
In case of the electrical part problem, check the follow
i
1. Check if the reflective connector, junction connect
o
Reconnect the connector.
2. Enter the diagnostic mode, and check the reflective
If the paper is at sensor and “Without paper” messa
g
3. Enter the diagnostic mode, and check the motor tes
If the motor is broken, replace it.
4. Check if the regi connector of engine controller is c
o
5. Replace the engine controller.
● Replacement part
- JC31-00132A : MOTOR STEP
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7-
8
s
hooting
m
achine.
w
ithin a regular time after passing the registration
a
t the Fuser In Sensor.
e
d paper.
a
me jam occurs, check the following.
e
r and the regi roller, remove it.
ixed correctly. If or not, disassemble the Guide and
ixed
correctly.
If
or
not,
disassemble
the
Guide
and
i
ng :
o
r on the middle of regi roller are connected properly.
sensor test.
g
e is displayed, replace the sensor.
t of the pick up drive unit.
o
nnected properly. Reconnect it.
SAMSUNG ELECTRONICS
8
3