Samsung CLX-9250ND - Page 427

7. Trouble
s
● Code :
M2-2313
● Error message :
Paper jam at the ins
i
● Symptom / Cause : Paper transport jam (paper I
- The paper has not reached the regi sensor within no
r
● Troubleshooting method :
1. Open the side door. Remove the jammed paper.
Close the side door. After warm up, if same jam oc
c
2. If there is any obstacles between the duplex feed ro
3. Check if the reflective sensor connector, junction c
o
Reconnect it.
4. Enter the diagnostic mode, and execute the reflecti
v
B th t If “With t ” i
B
e
th
e paper a
t
sensor.
If
“With
ou
t
paper
”
message
i
5. Enter the diagnostic mode, and execute the pick up
If the motor is not working, replace it.
6. Check if the regi connector on the engine controller
Reconnect it.
7. Replace the engine controller PBA.
● Replacement part
- JC31-00132A : MOTOR STEP
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7-
8
s
hooting
i
de of duplex path.
nput section)
r
mal time after passing the duplex jam 2 sensor.
c
urs, check the following.
ller and the regi roller, remove it.
o
nnector are connected properly.
v
e sensor test.
idi l d l th
i
s
di
sp
l
aye
d
, rep
l
ace
th
e sensor.
drive motor test.
is connected properly.
SAMSUNG ELECTRONICS
8
7