Samsung CLX-9250ND - Page 48

2. Product
d
5. Cleaning for OPC drum: The cleaning brush and
b
after image transfer to the paper.
6. Quenching for OPC drum: Quenching is done by i
at the end of every job.
7. Cleaning and quenching for transfer belt: The cle
a
grounding roller inside the transfer belt unit remo
v
8. ID sensors: The ID sensors detect the density of I
D
sensors for the line position adjustment (front, ce
n
[A]: Line position adjustment (front)
[B]: Line position adjustment (center) & proce
s
[C]: Line position adjustment (rear)
[D]: Humidity Sensor (Internal).
The ID sensor out
p
ut is used for the followin
g
:
pg
- Process control and for automatic line positi
o
- Skew correction
- Color registration adjustments for the latent i
Service Manual
CLX-9250/9350 series
2-
3
d
escription
b
lade remove remaining toner on the drum surface
lluminating the whole area of the drum with the laser
a
ning brush and blade clean the belt surface. The
v
es the remaining charge on the belt.
D
sensor patterns on the transfer belt. Three ID
n
ter, and rear) and process control.
s
s control
o
n
mage.
SAMSUNG ELECTRONICS
3
1