Printing_ 150
fonts as bitmap (Type 3) fonts. A font larger than the maximum
setting will be downloaded as an outline (Type 1) font.
This option lets you fine-tune the Automatic setting or override
the Download as Bit Image setting for the Advanced Font/Text
Options (see
"Advanced" on page 143).
- Send CTRL+D Before Each Job: Specifies whether the printer
will be reset at the beginning of every PostScript document. The
default is unchecked.
CTRL+D will reset your printer to its default setting to ensure that
prior jobs won't affect the current print job. CTRL+D may cause a
print job to fail if your printer is connected through a network. If
your document fails to print when sent to a printer connected
through parallel or serial ports, check this option.
- Send CTRL+D After Each Job: Specifies whether the printer
will be reset at the end of every PostScript document. The default
is checked.
CTRL+D will reset your printer to its default setting to ensure that
future print jobs won't be affected by the current print job.
CTRL+D may cause a print job to fail if your printer is connected
through a network. If your document fails to print when sent to a
network printer, uncheck this option.
If you click Reset, settings in the Advanced returns to the
default setting.
• Font Substitution: Displays the font substitution table and options
for changing the TrueType-to-printer font mapping. This option is
available only when you use the PS printer driver.
• Job Accounting: Allows you to associate user and account
identification information with each document you print.
- User permission: If you check this option, only users with user
permission can start a print job.
- Group permission: If you check this option, only groups with
group permission can start a print job.
• If you want to encrypt job accounting password, check Job
Accounting Password Encryption.
• Administrators can enable job accounting and configure
permissions in the control panel or SyncThru™ Web
Service. For the detailed information about them, refer to
the Administrator’s Guide.
7. Click OK until you exit the Properties or Printer properties window.
To Next Page
Loading...
