Media and tray_ 48
6. Adjust the paper length guide to the desired paper length.
7. After!loading paper into the tray, pinch the paper width guide and move it
toward the stack of paper until it lightly touches the side of the stack. Do
not press the guide too tightly to the edge of the paper, the guide may
bend the paper.
• Do not push the paper guide too far causing the media to wrap.
• If you do not adjust the paper width guide, it may cause paper
jams.
Do not overload the tray. Otherwise, it may cause paper jams.
Make sure that the paper is below the maximum paper capacity
guide inside the tray.
8. Fix the the paper length guide using the locking switch. Release the
locking switch to load a different sized paper.
1 Paper capacity guide
1 Locking switch
1
M A X
1
To Next Page
Loading...
