Do not use sharp objects, such as a knife or scissors, to open the
imaging unit package. You could damage the surface of the
imaging unit.
5. Go to ste
p.9 (CLX-92x1 Series only).
6. Pull ou
t the protecting pad (SCX-812x Series only).
If toner gets on your clothing, wipe it off with a dry cloth and wash
clothing in cold water. Hot water sets toner into fabric.
• Be careful not to scratch the surface of the imaging unit.
• To prevent damage, do not expose the imaging unit to light for
more than a few minutes. Cover it with a piece of paper to
protect it if necessary.
7. Pull the rubber stopper out of the developer (SCX-812x Series only).
8. Remove the tape on the imaging unit (SCX-812x Series only).
9. Remove the paper protecting the imaging unit.
10. Hold the handles on the new imaging unit, and push the imaging unit
until it locks into place.
To Next Page
Loading...
