Media and tray_ 41
6. Adjust the paper length guide to the desired paper length.
7. After loading paper into the tray, pinch the paper width guide and move it
toward the stack of paper until it lightly touches the side of the stack. Do
not press the guide too tightly to the edge of the paper: the guide may
bend the paper.
• Do not push the paper guide too far causing the media to warp.
• If you do not adjust the paper width guide, it may cause paper
jams.
Do not overload the tray: it may cause paper jams. Make sure that
the paper is below the maximum paper capacity guide inside the
tray.
1
M A X
1 Paper capacity guide
8. Fix the the paper length guide using the locking switch. Release the
locking switch to load a different sized paper.
1
1 Locking switch
9. Insert the tray back into the machine.
When you print a document, set the paper type and size for the tray.
For information about setting the paper type and size on the control
p
anel (see "Tray setting" on page 47).
The standard tray and optional dual ca
ssette feeder can automatically
detect various-sized paper (see "Media sizes automatically detected" on
page 44).
If you set the Tr
ay Confirmation Message ON in Tray Settings, the
confirmation window appears automatically (see "Setting the tray
confirmation message" on page 47).
Check if the paper size and type in the tr
ay are detected or not. If you
To Next Page
Loading...
