Samsung CLX-9350ND - EEPROM and Photo Sensor

3. Replaceme
n
3.5.6 EEPROM and photo sensor
Perform the following procedure to remove the EEPRO
1. Remove the Fuser front.
(
Refer to 3.5.3 ste
p
2~3
)
(p)
2. Remove the EEPROM[A] after removing 2 connecto
r
3. Remove the photo sensor shield after removing 1 sc
r
[A]
[B]
4 R th h t [C] f th hi ld [B]
4
.
R
emove
th
e p
h
o
t
o sensor
[C]
f
rom
th
e s
hi
e
ld
[B]
.
[C]
Service Manual
CLX-9250/9350 series
3-
3
n
t Procedures
M and Photo Sensor from the Fuser Unit.
r
s, 1 screw and opening the wire saddle.
r
ew.
CAUTION
Be careful not to damage in harness.
The damage of the harness can make a fire
caused by a short circuit.
The EERPROM can be damaged by a
electrical or physical shock.
SAMSUNG ELECTRONICS
3
7