Installation
English24
Installation
4. Draw back the clamp as shown.
5. Connect the wire connectors.
CAUTION
• Make sure the wire connectors are
connected properly. Otherwise, the
display does not operate.
6. Connect the water tube.
CAUTION
• To prevent water leaks, make sure the
red clips tighten the coupler properly.
• Keep the clips out of children’s reach.
7. Repeat the above steps for the other
door.
8. Attach the top cover with the front side
rst, and then press down on its back
to t into position. Then, tighten the
screws (x3).
Untitled-1 24 2016-09-29 7:40:37
To Next Page