English - 36
• If a power failure occurs, ice cubes
may melt then freeze together when
the power comes back on, causing the
dispenser to stop working.
To prevent this problem, after a power failure, pull out
the ice bucket and discard the residual ice or water.
• If you use all the ice at once, you must
repeat ice making Steps 2 and 3.
However, only wait 8 hours before
dispensing the fi rst 4 to 6 ice cubes.
This will replenish the ice cubes and
ensure maximum ice production.
USING THE ICE OFF FUNCTION
When you select the Ice O mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it di cult to
remove them.
To remove the ice bucket safely and avoid injury,
hold the bottom of the bucket with one hand and
the side of the bucket with the other.
Then, lift up on the ice bucket, and pull it straight
out.
To put the ice bucket back in, push it fi rmly straight
back.
• If the ice bucket is not pushed fi rmly into
place, ice in the bucket can melt.
If the bucket does not fi t, turn the helix 90 degree
(see the last illustration on the right, below) and try
again.
CAUTION
• The inside of the ice bucket stays cold
when it is operating.
Do not reach deep inside the ice bucket.
• Use only the ice maker provided with the
refrigerator.
The water supply to this refrigerator must
be installed/connected by a suitably
qualifi ed person.
Connect to a potable water supply only.
GOING ON VACATION...
If you are going on a long vacation or business trip
and won’t use the water or ice dispensers for a long
time:
- Close the water valve.
Otherwise, water leakage may occur.
- Remove all food and ice in the ice bucket.
- Unplug the refrigerator.
- Wipe excess moisture from inside and leave the
doors open. Otherwise, odor and mold may develop.
CAUTION
CAUTION
DA68-03013E-03.indb 36DA68-03013E-03.indb 36 2015. 8. 26. 10:382015. 8. 26. 10:38
To Next Page
Loading...
