Installation
Installation
English18
3. When both sides of the panel lock
into place, press the top center of the
Bespoke panel to secure it to the top of
the door.
NOTE
• Make sure that the Bespoke panel ts in
the dishwasher properly.
• If the gap between the dishwasher
and the Bespoke panel is below 2 mm,
proper installation is done. For 2 mm or
more, remove the Bespoke panel and
try again.
4. Unpack the caps and screws (two for
each) included in the product package.
5. Tighten the screws on either side of the
dishwasher.
NOTE
When tightening the screw on either side,
make sure to check the gap between either
side as the Bespoke door may lean in
either side.
DW5000C_DW80CB507012AA_DD68-00260A-00_EN.indd 18DW5000C_DW80CB507012AA_DD68-00260A-00_EN.indd 18 2023-05-03 11:50:032023-05-03 11:50:03
To Next Page
Loading...
