Storing Channels in Memory (Automatic Method)
1 Press the MENU button
to
display the menu.
Press the
~
or T button to select Channel, then press the ENTER button.
2 Press the
~
or T button to select
Auto
Program, then press the ENTER
button.
3 Press the
~
or T button to select the antenna connection, then press the
ENTER button.
~
Air: "Air" antenna signal.
Cable: "Cable" antenna signal.
Air+Cable: "Air" and "Cable" antenna signals.
~
If the antenna
is
connected
to
ANT 2
IN
(CABLE), select Cable and if
it
is
connected to ANT 1
IN
(AIR), select Air.
~
If both ANT 1
IN
and
ANT 2
IN
are connected, select
Air
+ Cable.
~
If you selected Air, then go
to
step
5.
4 Press the
~
or T to select the correct analog signal cable system source
among STD, HRC and IRC, then press the ENTER button. If you have Digital
cable
TV,
select the cable system signal source for both Analog and Digital.
~
STD, HRC and IRC identify various types of cable TV systems. Contact your
local cable company to identify the type of cable system that exists
in
your
particular area. At this point the signal source has been selected.
5 The TV begins memorizing
all
available stations.
If
you
want to stop Auto Programming, press the ENTER button. The Stop
Auto
Program? message will
be
displayed. Select Yes by pressing the
....
or
~
button.
Press the EXIT button
to
exit.
~
The Wireless Home
AV
Center must be connected to a/an antenna/cable
in
order to receive digital TV signals. Even if a particular channel
is
deleted
from the memory, you
can
always tune
to
that channel directly by using the
number buttons
on
the remote control.
~
•
All
available DTV
and
analog channels are automatically stored
in
memory.
•
It
takes approximately 3
to
10
minutes
to
memorize channels.
Your Wireless Home
AV
Center can memorize and store all
of
the available channels
for
both air and cable
channels.
After
the available channels are memorized, use the
CH
A
or
CH
v
button
to
scan
through
the
channels. This eliminates the need
to
change channels
by
entering the channel digits. There are three steps
for
memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding and
deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must
specify the type of signal source that
is
connected to the Wireless Home
AV
Center
(i.e.
an
air or a cable system).
1 Press the MENU button
to
display the menu.
Press the
~
or T button
to
select Channel, then press the ENTER button.
2 Press the ENTER button select Antenna.
Press the
~
or T button
to
select
Air
or Cable, then press the ENTER button.
Press the EXIT button
to
exit.
Memorizing
the
Channels
I
~
You
can also press the AUTO PROG. button
on
the remote control
to
bring up the Auto
Program menu.
[
--~--~~G--~--~--
oif'f
':JREstT
--------------
..
-.-.-------_.
To Next Page
Loading...
