225
5. If the TV turned on, tap
Yes, this code 1 works
.
– or –
If the TV did not turn on after tapping (
Power
)
and waiting 10 seconds, tap
No, test next code 2
or
Send this code 1 again
.
6. From the
Select your channel source
screen, select the
entry that corresponds to your current channel
selection method:
• Set-top Box
: selected when changing channels is done via a
receiver box. Channels are not changed via the TV remote but
rather through the receiver/box.
• My xxx TV
: selected when a signal is fed directly into the TV
and no box is used. Channels are changed directly on the TV by
using the TV remote and not a box’s remote.
Note:
Try matching your current channel selection method.
7. If you selected
Set-top box
, Select your Set-top Box
brand.
8. From the
Test Set-top box
screen, tap the
CH
button up
or down, then respond to the
Setup
prompt according
to whether the channel changed, by tapping
Send this
code 1 again
;
No, test next code 2
; or
Yes, this code 1
works
.
After you successfully change the channel using
WatchON, the WatchON
Easy remote
screen displays.
For more information, refer to “Using WatchON” on
page 226.
Tip:
If you have a satellite system and a set-top box,
see “Satellite System Set-Top Box Setup” on
page 226.
To Next Page
Loading...
