1. Push the jig deep in the opening hole
2. Push down the jig and pull up the rear cover
till it opens.
3. Do the step 2 in opposite side until it opens.
4. Push the jig in the bottom center of the rear
cover.
5. Pull up the jig and the corner of rear cover at
the same time.
6. Do the step 5 in the opposite side until it
opens.
3 Disassembly and Reassembly
3-2 GH17P*/GH18P*
3-3 Disassembly
Reassembly procedures are in the reverse order of Disassembly procedures.
To Next Page
Loading...
