ŝ153Ş
Using an External Flash (Optional)
ƃ In Wireless Mode
1. Place the SEF-36PZF at the desired location.
2. Set the SEF-36PZF power switch to [WIRELESS].
3. Set the SEF-36PZF wireless mode to S (Slave).
4. Turn the camera mode dial and set the exposure mode to , , or mode.
5. Set the SEF-36PZF power switch on the camera to [WIRELESS].
6. Set the SEF-36PZF wireless mode on the camera to (Master) or (Control).
ƃ Wireless mode is not available for the built-in flash.
ƃ Set the SEF-36PZF wireless slave mode to SLAVE1.
ƃ See the SEF-36PZF operating manual for details.
INFORMATION
Wireless Flash Control (P-TTL Flash Mode)
The following information is exchanged between the two SEF-36PZF flash units before the flash is
discharged when the SEF-36PZF is used for wireless flash.
Press the shutter release button fully.
1. The cameraŖs flash discharges a pre-flash (the cameraŖs flash mode is transmitted).
2. The external flash unit discharges a pre-flash (the subjectŖs lighting condition is checked).
3. The cameraŖs flash unit discharges a pre-flash (the required flash output is transmitted to the
external flash).
ſ The cameraŖs flash will discharge another pre-flash to transmit the flash duration in HS
(High-speed sync).
4. The external flash discharges the main flash.
ſ Set the SEF-36PZF wireless slave mode to SLAVE1.
Downloaded From camera-usermanual.com Samsung Manuals
To Next Page
Loading...
