Speaker Components
Installing the Speakers on the Tallboy Stand
Turn the Stand Base upside-down and connect
it to the Stand.
Insert small screws (4*20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
CAUTION :
When you use a torque screw-
driver, be careful not to put excessive force.
Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm
Connect the upper Speaker to the assembled Stand.
Insert another large screw (5*15, For connecting
Speaker & Stand) clockwise into the hole on the
rear of the speaker using a screwdriver.
This is the appearance after the speaker is
installed. Follow this steps to install other
speaker.
1.
2.
!
3.
4.
5.
To Next Page
Loading...
