f
1 Remove the battery
cover on the back of
the remote by pressing
down and sliding the
cover in the direction of
the arrow.
2
Insert two 1.5V AAA
batteries, paying
attention to the correct
polarities (+ and -).
3 Replace the battery
cover.
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity:(+) to (+)and (-)to (-),
• Use the correct type of batteries.Batteries that look similar may differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
ofOperationofthe RemoteControl
The remote control can be used up to approximately 23 feet/7 meters in a straight line. It can also be
operated at a horizontal angle of up to 30° from the remote control sensor.
12
To Next Page
Loading...
