Samsung HW-C450 - Initialization & Update

Samsung Electronics 4-17
Troubleshooting
4-3 Initialization & Update
4-3-1How to check the Firmware version
1. Turn the power off.
2. Press the “DRC” button on the remote control.
3. After blinking “Standby red LED”, the version will be displayed on the VFD.
4-3-2How to initialize
1. Using the remote control
1) Turn power off.
2) Press for 5 seconds “MUTE” button in remote.
3) Stanby LED becomes OFF, and Volume LED is lighted.
4) If Volume LED becomes OFF, and Stand-by LED becomes ON, initialization is ended.