If the Wireless Receiver Module is not linked to your soundbar (displaying the LED indicator in Red),
connect them as follows.
1. Turn off your soundbar.
2. Press the
(Mute) button on your remote control for 5~6 seconds until the ID SET message appears on your
soundbar display.
3. Check the Wireless Receiver Module is in Standby status (displaying the LED indicator in Red).
4. Press the ID SET button on the back of the Wireless Receiver Module with a sharp pin for 5~6 seconds until the
LINK LED indicator on the Wireless Receiver Module blinks (in Blue).
5. Turn on your soundbar with the
button on your remote control and wait for a while. They are completely
connected to each other if you can see the LINK LED indicator is continuously lit (in Blue).
CONNECTING THE SURROUND SPEAKERS
(SOLD SEPARATELY)
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
ID SET
L
R
Surround Speaker (L) Surround Speaker (R)
Wireless Receiver Module
● Place these speakers to the side of your listening position. If there isn't enough room, place these
speakers so they face each other. Position them about 2 to 3 feet above your ear, facing slightly
downward.
● Surround speakers must be connected to the Wireless Receiver Module.
● Each speaker has a colored label on its back or underside. Each cable has a single colored band near its
end. Match the band on each cable to the speaker label by color, and then connect the cable to the
speaker.
To Next Page
Loading...
