Samsung HW-M370 - Page 16

ENG - 10
2. Check the standby status after plugging into an electrical outlet
Plug the Wireless Receiver Module power cord into an electrical outlet and into the Wireless Receiver
Module to turn on the Wireless Receiver Module. The LINK LED indicator (blue LED) on the Wireless
Receiver Module blinks. If the LED does not blink, refer to step 7 on page 11.
ID SET
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
STANDBY
LINK
STANDBY
LINK
Blue blinking
3. Turn off the Soundbar
Turn off the Soundbar using the Soundbar’s remote control or by pressing the (Power) button on the
main Soundbar unit.
OFF
4.Congure“IDSET”usingtheSoundbar’sremotecontrol
Press the VOL button on your remote control for 5~6 seconds until the “ID SET” message appears on
your Soundbar’s display.
Surround
SOUND
MODE
Bluetooth
POWER
VOL
WOOFER
SOUNDBAR
5 Sec
ID SET