ENG - 11
5. Turn on the Soundbar
Turn on the Soundbar using the Soundbar’s remote control or by pressing the (Power) button on the
main Soundbar unit.
ON
6. Check if the LINK LED is solid blue (connection complete)
STANDBY
LINK
Blue is On
The LINK LED indicator stops blinking and glows a
solid blue when a connection is established between
the Soundbar and the Wireless Receiver Module.
7. If the Wireless Surround Speaker does not connect, take the necessary steps
according to the LED Indicator’s status
LED status Action
LINK (Blue)
On Connected with the Soundbar -
Blinking Connection standby status
Check if the Soundbar is turned on
Repeat steps 3 through 6.
STANDBY
(Red)
On Connection failure
Check if the Soundbar is turned on
1. Press the ID SET button on the back of the
Wireless Receiver Module with a pen tip for
5~6 seconds until the LINK LED indicator blinks
(in Blue).
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
ID SET
5 Sec
2. Repeat steps 3 through 6.
Others - Errors Contact a Samsung Service Center.
To Next Page
Loading...
