Samsung HW-MM36 - Page 17

ENG - 11
7. If the SWA-8500S does not connect, take the necessary steps according to the LED Indicator’s
status.
LED status Action
LINK (Blue)
On
Connected with
the Soundbar
-
Blinking
Connection
standby status
Check if the Soundbar is turned on
Repeat steps 3 through 6.
STANDBY
(Red)
On
Connection
failure
Check if the Soundbar is turned on
1. Press the ID SET button on the back of the Wireless
Receiver Module with a pen tip for
5~6 seconds until the LINK LED indicator blinks (in
Blue).
ID SET
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
ID SET
5 Sec
2. Repeat steps 3 through 6.
Others - Errors Contact a Samsung Service Center.