Samsung HW-MM55C - Connecting the Soundbar (continued)

ENG - 9
2. Plug in the Wireless Receiver Module, and then check its standby status.
• The LINK LED indicator (blue LED) on the Wireless Receiver Module should blink. If the LED
does not blink, press the ID SET button on the back of the Wireless Receiver Module with a pen
tip for 5~6 seconds until the LINK LED indicator blinks (in Blue). For more about the LED, please
refer to the SWA-8500S user manual.
ID SET
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
STANDBY
LINK
STANDBY
LINK
ID SET
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
ID SET
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
STANDBY
LINK
STANDBY
LINK
ID SET
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
Blue blinking
3. Turn off the Soundbar using the Soundbar’s remote control or by pressing the (Power) button
on the main Soundbar unit.
4. Press and hold the VOL button on the remote control for at least 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then disappears.
Surround
SOUND
MODE
Bluetooth
POWER
VOL
WOOFER
SOUNDBAR
5 Sec
ID SET
CAUTION
• If your Soundbar was playing music when it connects to the SWA-8500S, you may hear some
stuttering from the woofer as the connection nalizes.
5. Turn on the Soundbar using the Soundbar’s remote control or by pressing the (Power) button
on the main Soundbar unit.
6. Check if the LINK LED is solid blue (connection complete).
STANDBY
LINK
STANDBY
LINK
Blue is On
The LINK LED indicator stops blinking and
glows a solid blue when a connection is
established between the Soundbar and the
Wireless Receiver Module.
7. If the SWA-8500S is not connected, repeat the procedure from Step 2.