ENG - 15
CAUTION
• If your Soundbar was playing music when it connects to the SWA-9100, you may hear some stuttering from the woofer as the connection
nalizes.
4. Check if the LINK LED is solid blue (connection complete)
STANDBY
LINK
Blue is On
The LINK LED indicator stops blinking and glows a solid blue when a connection
is established between the Soundbar and the Wireless Receiver Module.
5. If the SWA-9100 does not connect, take the necessary steps according to the LED Indicator’s status
LED status Action
LINK (Blue)
On Connected with the Soundbar -
Blinking Connection standby status
Check if the Soundbar is turned on
Repeat steps 3 through 4.
STANDBY (Red) On Connection failure
Check if the Soundbar is turned on
1. Press the ID SET button on the back of the Wireless
Receiver Module with a pen tip for 5~6 seconds until the
LINK LED indicator blinks (in Blue).
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
5 Sec
2. Repeat steps 3 through 4.
Others - Errors Contact a Samsung Service Center.
To Next Page
Loading...
