Samsung HW-Q870A - TV Remote Control Volume Adjustment

ENG - 11
Output specications for the different sound effect modes
Effect Input
Output
With Subwoofer & Surround Speaker
STANDARD
2.0 ch 2.1 ch
5.1 ch 5.1 ch
SURROUND
2.0 ch 5.1.4 ch
5.1 ch 5.1.4 ch
GAME PRO
2.0 ch 5.1.4 ch
5.1 ch 5.1.4 ch
ADAPTIVE SOUND
2.0 ch 5.1.4 ch
5.1 ch 5.1.4 ch
• When the input source is Dolby Atmos®, DTS:X, the Subwoofer-only setup provides 3.1.2 channel audio, while the Subwoofer & Surround
Speaker Kit setup provides 5.1.4 channel audio.
• The Surround Speakers will not produce sounds for 2 channel output while STANDARD mode is in use. To enable sound for the Surround
Speakers, change the effect mode to SURROUND.
Adjusting the Soundbar volume with a TV remote control
Adjust the Soundbar volume using the TV’s remote control.
• This function can be used with IR remote controls only. Bluetooth remote controls (remote controls that require pairing) are not
supported.
• Set the TV speaker to External Speaker to use this function.
• Manufacturers supporting this function:
VIZIO, LG, Sony, Sharp, PHILIPS, PANASONIC, TOSHIBA, Hisense, RCA
1. Turn Off the Soundbar.
Push up and hold the WOOFER button for 5 seconds.
Each time you push the WOOFER button up and hold it for 5 seconds, the mode switches in the following order: “OFF-TV REMOTE” (Default
mode), “SAMSUNG-TV REMOTE”, “ALL-TV REMOTE”.
Remote Control Button Display Status
SOUND
MODE
VOL
WOOFER
SOUNDBAR
(Default mode)
OFF-TV REMOTE
Disable the TV remote control.
SOUND
MODE
VOL
WOOFER
SOUNDBAR
SAMSUNG-TV REMOTE
Enable a Samsung TV’s IR remote control.
SOUND
MODE
VOL
WOOFER
SOUNDBAR
ALL-TV REMOTE
Enable a third-party TV’s IR remote control.