ENG - 4
03 CONNECTING THE
SOUNDBAR
Connecting Electrical Power and
Subwoofer
HDMI IN 1
HDMI IN 2
ID SET
(WOOFER,
REAR)
NETWORK
SERVICE
DIGITAL AUDIO IN
(OPTICAL)
HDMI TO TV
(eARC/ARC)
HDMI 1
HDMI 2
ID SET
POWER
HDMI IN 1
HDMI IN 2
ID SET
(WOOFER,
REAR)
NETWORK
SERVICE
DIGITAL AUDIO IN
(OPTICAL)
HDMI TO TV
(eARC/ARC)
HDMI 1
HDMI 2
ID SET
Rear of Subwoofer Bottom of the Soundbar Main Unit
Manually connecting the
Subwoofer
1. Turn off the Soundbar main.
2. Press and hold ID SET on the rear of the subwoofer
for at least 5 seconds.
Rear of Subwoofer
"Blinking blue fast"
5 sec
3. Press the Up button on the remote control for
5 seconds.
PAIR
5 sec
ID SET
4. Check if the LINK LED is solid blue (connection
complete).
• The LINK LED indicator stops blinking and glows
a solid blue when a connection is established
between the Soundbar and the Wireless
Subwoofer.
Auto EQ
AUTO EQ technology uses the subwoofer’s built-in
microphone to measure the frequency response and
calibrate the BASS performance.
• You must keep the room as quiet as possible while
operating the Auto EQ tuning.
• Do not use any buttons until the Auto EQ tuning is
complete.
• During Auto EQ Tuning, there is no sound from the
Soundbar’s main unit and rear speakers.
04 USING A WIRED
CONNECTION
1
HDMI Cable
2
Optical Cable (not
supplied)
HDMI IN
(ARC)
HDMI OUT
DIGITAL AUDIO IN
(OPTICAL)
HDMI TO TV
(eARC/ARC)
HDMI 2
HDMI 1
1
1
Connecting using an HDMI Cable
(External Device (HDMI 1 or HDMI 2) / TV ARC)
OPTICAL OUT
DIGITAL AUDIO IN
(OPTICAL)
2
Connecting using an Optical Cable (D.IN)
NOTE
• When the TV sound is not output, press the (Multi
Function) button at the top of the Soundbar or the
(Source) button on the remote control to select
the “D.IN” mode. The screen displays “D.IN” and “TV
ARC” in sequence, and TV sound is played.
• The recommended cable is High Speed HDMI Cable
with Ethernet.
• When you use an optical cable and the terminals have
covers, be sure to remove the covers.
Using the Q-Symphony Function
For Q-Symphony, the Soundbar syncs with a Samsung
TV to output sound through two devices for optimum
surround effect. When the Soundbar is connected, the
menu, “TV+Soundbar” appears under the Sound Output
menu of the TV.
• TV menu example: TV + [AV] Soundbar series name
(HDMI)
NOTE
• It can operate according to the Codec supported by
TV.
• This function is supported only when the HDMI Cable
or Optical Cable (not supplied) is connected.
• This function is available in some Samsung TVs and
some Soundbar models.
• When using Q-Symphony, you can only choose GAME
PRO or ADAPTIVE SOUND.
To Next Page
Loading...
