Samsung HW-Q910B - Connecting the Soundbar and Surround Speakers; Power and Unit Connections; Manual Subwoofer;Surround Speaker Connection; Wireless Receiver Setup (SWA-9100)

03 CONNECTING THE
SOUNDBAR
Connecting the power and units
fil
Rear of Subwoofer
Sound bar Main Unit
Manually
connecting the Subwoofer
or Surround Speakers
1. Turn off the Sound bar main.
2. Press and hold ID SET on the rear of the subwoofer and
surround speakers
for at least 5 seconds.
• The surround speakers may
not be provided,
depending on
the model.
Rear of Subwoofer
"Blinking blue fast"
3. Press
the Up button on the remote control for
5 seconds .
..
4. Check if the LI NK LED is solid blue (connection
complete).
• The LINK
LED indicator stops blinking and glows a
solid blue when a connection is established between
the Sound bar and the Wireless Subwoofer, surround
speakers.
Connecting an SWA-9100 to your
Soundbar
1. Connect the Wireless Rece i ver Module to 2 Surround
Speakers
Use the speaker cables to connect the two surround
sound speakers
to the Wireless Receiver Module.
2. Check the standby status after plugging into an
electrical outlet
The LINK L
ED indicator (blue LED) on the Wireless
Receiver Module blinks.
If the LED does n ot b li n k, press
the ID SET button on the back of the Wirele ss Re ceiver
Mo
dule with a pen tip for 5-6 seconds unt il the LI NK
L
ED indicator blinks (in Blue).
■
..
"Blue
3. Configure "ID SET" using the Soundbar 's remote control
Turn off the Sound bar main. Press the Up bu tton on the
remote control for 5 seconds.
""' W-.. """"- . T ~.__.. .... _.,.. t .... --~-., •
~
➔ ---
. ·~ -- ·~· .,..-:~--
4. Check if the LINK LED is solid blue (connection
complete)