Manually connecting the Subwoofer or Surround Speakers
1. Turn off the Soundbar main.
2. Press and hold ID SET on the rear of the subwoofer and surround speakers for at least 5 seconds.
3. Press the Up button on the remote control for 5 seconds.
4. Check if the LINK LED is solid blue (connection complete).
• The LINK LED indicator stops blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Subwoofer, surround speakers.
Auto EQ
AUTO EQ technology uses the subwoofer’s built-in microphone to measure the frequency response and calibrate the BASS performance.
You must keep the room as quiet as possible while operating the Auto EQ tuning.
Do not use any buttons until the Auto EQ tuning is complete.
During Auto EQ Tuning, there is no sound from the Soundbar’s main unit and rear speakers.
HDMI Cable
Optical Cable (not supplied)
Connecting using an HDMI Cable
(External Device (HDMI 1 or HDMI 2) / TV ARC)
To Next Page
Loading...
