Samsung HW-T550 - Manually Connecting the Subwoofer if Automatic Connection Fails

Manually connecting the Subwoofer if automatic connection fails
Before performing the manual connection procedure below:
• Check whether the power cables for the Sound bar and subwoofer are connected properly.
• Make sure that the Sound bar is turned on.
1. Press and hold ID SET on the rear of the subwoofer for at least 5 seconds.
• The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.
Rear of Subwoofer
2. Press and hold the Up button on the remote control for at least 5 seconds.
• The ID SET message appears on the display of the Sound bar for a moment, and then it
disappears.
• The Soundbar will automatically power on when ID SET is complete.
SAMSUNG logo is on the top
IDSET
3. Check if the LINK LED is solid blue (connection complete).
Blue is On
ENG-6
The LINK LED indicator stops blinking and
glows a solid blue when a connection is
established between the Sound bar and the
Wireless Subwoofer .