This content should be recognized by the customer who runs the screen
Please print it out by the installer and deliver it to the customer (user)
Dehumidification mode guide – LSM
Installation when dehumidification is required
※ Do not play or use other content before the instructions on the next page are completed.
※ In humid areas, using a dehumidifier to reduce moisture is effective.
(Moisture increases when the night air conditioner does not work, which can be a factor in line effect.)
※ Please make sure that the cold air in the air conditioner does not directly touch the screen.
※ If you use a temperature / humidity meter during the installation period, you can analyze the cause in case of a problem.
1. After connecting the cabinet, run a specific pattern on the LSM.
(If a different pattern is used, it may be a cause of line defect. )
2. Check the cabinet with a darker monochromatic pattern (W/R/G/B) and turn off the cabinet.
(The inspection of each pattern must be within 30 seconds, and for more information,
please refer to the screen inspection..)
① After selecting the installation model, run Test
Pattern
② Run a darker gray pattern among patterns
※ Screen when connecting 110 inch set
To Next Page
Loading...
