LED R&D Lab(VD)
47
6. S-Box Installation and Connection
• Pushing in of plastic loader to fullest extent: Push the plastic load bar as close as possible to the cable.
• Use a wire stripper to cut all conductors (conducting wires) down to a length of about 0.5 inches.
• With drain wire: Refer to the next page.
※ Without drain wire: Use copper foil to contact the connector shell part, as shown below.
Copper foil
Fold aluminum foil or braid back and wrap it with copper foil.
Connector shell
• S-Box connection
⑩ Finishing the HDBaseT cable after installation
To Next Page
Loading...
